Hi you guys
I know there are RWS controller users on this list.
Hopefully no one has replicated this failure mode in their installation.
Here is the link
http://www.eaa.org/news/2010/2010-03-08_landing.asp
Basically the mounting nut was only a few threads on and despite a locking
washer, worked lose and fell on to the circuit board and moved around until
it shorted something out. Despite two separate circuits' the short downed
the plane fortunately no one was hurt.
It is apparent that it must have shorted the main feed to both sides, as the
plane was trailerd to the home field and the fault identified.
The pilot is to be congratulated for making a safe landing causing no damage
to himself/others or his plane, but more so for sharing the cause of his
misfortune.
Clive ...........England
A drop of RTV around and on top of the nuts would have prevented
this. I am glad it was not a rotary.
Soobs vibrate harder than rotaries.
It is also a good idea to mount your computer with rubber shock
mounts. Search "rubber isolators" in McMaster Carr.
Use three of the 2 pound versions. I am sure the box weighs
much less than 6 pounds. So add a bit of steel sheet to the box
and get it up to six pounds. That gets the resonant
frequency as low as possible.
" Vibration-Damping Mounts— Isolate vibration, shock, and
noise transmitted to and from machinery. They reduce maintenance
costs, prolong equipment life, and protect floors. Performance
is measured by deflection (the distance the mount material moves
when subjected to force). Generally, the higher the deflection
rating, the greater the vibration, shock, and noise isolation."
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.