Subject: RWS COMPLETE IN-FLIGHT SHUT DOWN MOUNTING ISSUE Not a rotary.
From: Rotary Engine
Date: 3/14/2010, 8:55 AM
To: AAA Put this in the To box


 Hi you guys

 I know there are RWS controller users on this list.

 Hopefully no one has replicated this failure mode in their installation.

 Here is the link

 http://www.eaa.org/news/2010/2010-03-08_landing.asp

 Basically the mounting nut was only a few threads on and despite a locking
 washer, worked lose and fell on to the circuit board and moved around
 until
 it shorted something out.   Despite two separate circuits' the short
 downed
 the plane fortunately no one was hurt.

 It is apparent that it must have shorted the main feed to both sides, as
 the
 plane was trailerd to the home field and the fault identified.

 The pilot is to be congratulated for making a safe landing causing no
 damage
 to himself/others or his plane, but more so for sharing the cause of his
 misfortune.

 Clive ...........England


 A drop of RTV around and on top of the nuts would have prevented
 this. I am glad it was not a rotary.
 Soobs vibrate harder than rotaries.

 It is also a good idea to mount your computer with rubber shock
 mounts. Search "rubber isolators" in McMaster Carr.
 Use three of the 2 pound versions. I am sure the box weighs
 much less than 6 pounds. So add a bit of steel sheet to the box
 and get it up to six pounds. That gets the resonant
 frequency as low as possible.

 "  Vibration-Damping Mounts? Isolate vibration, shock, and
 noise transmitted to and from machinery. They reduce maintenance
 costs, prolong equipment life, and protect floors. Performance
 is measured by deflection (the distance the mount material moves
 when subjected to force). Generally, the higher the deflection
 rating, the greater the vibration, shock, and noise isolation."

 Paul Lamar

Paul,

No shock mounts. Tracy is adamant about the need to ground the case. I'd
like to see it shock mounted too. I know you are going to provide all sorts
of options for getting around that. But you and I didn't design the box.
Mine is mounted per the designer's instructions.

Mike Wills

That is a very strange position for Tracy to take. Looks like he
paid a price for that position. One can ground the case and
still use shock mounts. Are you sure he is against shock
mounting per se or do you think he just thinks it won't be
grounded? In plastic air planes it must be grounded with
a wire in any case.

Just about all electronic equipment is shock mounted in
air liners and has been for decades.

Braided steel sleeve or ribbon is usually used for grounding.

Here is perhaps a better shock mount that grounds as well
as vibration isolating. No need for ballast as it has a
lower load rating.


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.