Subject: RWS COMPLETE IN-FLIGHT SHUT DOWN MOUNTING ISSUE Not a rotary.
From: Rotary Engine
Date: 3/14/2010, 5:55 PM
To: AAA Put this in the To box


Hi you guys

I know there are RWS  controller users on this list.

Hopefully no one has replicated  this failure mode in their installation.

Here is the  link

http://www.eaa.org/news/2010/2010-03-08_landing.asp

Basically  the mounting nut was only a few threads on and despite a locking
washer, worked lose and fell on to the circuit board and moved  around
until
it shorted something out.   Despite  two separate circuits' the short
downed
the plane  fortunately no one was hurt.

It is apparent that it must have  shorted the main feed to both sides, as
the
plane was  trailerd to the home field and the fault identified.

The pilot  is to be congratulated for making a safe landing causing no
damage
to himself/others or his plane, but more so for sharing the  cause of his
misfortune.

Clive  ...........England


A drop of RTV around and on top of the  nuts would have prevented
this. I am glad it was not a  rotary.
Soobs vibrate harder than rotaries.

It is also  a good idea to mount your computer with rubber shock
mounts. Search  "rubber isolators" in McMaster Carr.
Use three of the 2 pound  versions. I am sure the box weighs
much less than 6 pounds. So add a  bit of steel sheet to the box
and get it up to six pounds. That gets  the resonant
frequency as low as possible.

"   Vibration-Damping Mounts? Isolate vibration, shock, and
noise  transmitted to and from machinery. They reduce maintenance
costs,  prolong equipment life, and protect floors. Performance
is measured  by deflection (the distance the mount material moves
when subjected  to force). Generally, the higher the deflection
rating, the greater  the vibration, shock, and noise isolation."

Paul  Lamar

Paul,

No shock mounts. Tracy is adamant about the need to  ground the case. I'd
like to see it shock mounted too. I know you are going  to provide all sorts
of options for getting around that. But you and I  didn't design the box.
Mine is mounted per the designer's  instructions.

Mike Wills

That is a very strange position for  Tracy to take. Looks like he
paid a price for that position. One can ground  the case and
still use shock mounts. Are you sure he is against  shock
mounting per se or do you think he just thinks it won't  be
grounded? In plastic air planes it must be grounded with
a wire in  any case.

Just about all electronic equipment is shock mounted  in
air liners and has been for decades.

Braided steel sleeve or  ribbon is usually used for grounding.

Here is perhaps a better shock  mount that grounds as well
as vibration isolating. No need for ballast as  it has a
lower load rating.


Paul Lamar



Of course you can ground electronic equipment when isolated. Witness
composite aircraft. Make sure you use the strap indicated or a significantly
sized wire. Resistance goes up as the gauge of the wire goes up.

the grounding "ribbons" are used when there is a great deal of vibration as
they last longer than vibrated wires under these circumstances.
Electrically  they look the same as a thick multi stranded wire.

Rich



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.