Since i joined the group i know several of you are doing
some tig welding and i need some advise and comments
to find the cheapest unit and the appropriate one for
my project,i will have to weld my drive housing with
reinforcement gusset of 1/4 " thickness aluminum plate
and to 1/2 plate i found lot on the market true EBAY
and CraigLists.com.
I handle pretty good the acetylene torch , have
welded 2 chromemoly tubing Dafhne frames and with
a few practice i am convince i will be fine to
handle the tig welding.
As per some expert they say i will need minimum
250 amps for the 1/2" plate
Jean Prudhomme
Jean,
You do not want the cheapest welder you can find, especially to weld Al.
The low cost ones usually only have a 20% duty cycle. That means only 12
minutes per hour. To weld the 1/2" Al., I would look for a unit that gives
40 to 50% duty cycle. Cost likely $3000 and up a bit.
Dale Davies
Jean,
1/2" aluminum plate is the tough part. I have a Miller Syncrowave 250 that
would do it but it cost 3K+ when I bought it. If cost is your biggest
sticking point I would suggest looking into one of the inverter technology
welders from Miller or Lincoln. When looking be sure to mention the need to weld
1/2" aluminum plate which may be too tough for them. You will need a water
cooled torch I'm sure. That isn't something that comes with the inverter
style welders from either manufacturer I believe. The Syncrowave products
are often sold in package deals which can often be negotiated on price. That
may be your best bet, but don't think anything with the capability to weld
thick aluminum will be cheap. Note also that you will need at least a 50
amp 220 service in your shop.
Bill Jepson
Make sure the Tig Welder has High Frequency.
Henry.
Thank,s everybody i made my choice to the INVERTIG 201 and
there is an article regarding the unit
http://www.hemmings.com/hmn/stories/2008/08/01/hmn_feature21.html
Jean Prudhomme
Jean, I don't think you will be dissappointed in that choice. I took a one day intro class
at HTP in Chicago, I was welding .025 al sheet butt welds within minutes. (I confess to
having some previous welding experience). There is a lot of capability in that machine.
All the settings may seem daunting at first, but they allow you to tailor the heat for
very precise welds. That precision also makes it "easier" for the novice to begin being
productive. Buy or aquire a pile of scrap metal of the alloys you wish to work with, make
coupons (test strips) to practise on. Jeff will give you advise on any projects, he not
only runs the business but is an experienced fabricator himself.
Work Safe!
C. Smith
C. Smith where are you located,i will be at Sun
And Fun next month do you think they will have a booth there??
Jean Prudhomme
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.