Hi Paul-
I've been staring at the PPort install, wondering how to modify the
oil cooler install I currently have (if I end up needing to). One of
the things that strikes me is how much interference is caused by the
engine mount tubes in the S-Beam configuration. They're everywhere,
and can make it quite a challenge to put other components (e.g., oil
coolers) where you might want them. Not that I have any intention of
making sweeping changes to my install, but it got me thinking.
It occurred to me that simply reimplementing the 13b front cover might
allow for a design that was dynafocal friendly -- without trying to
mess with more complex engine parts (e.g., end housings) -- might be
possible. I note that in a recent posting there were Rhino drawings
that had Dynafocal in their names that are probably along the same
lines of thinking.
Following this chain of thought, I have two concerns about the
robustness of this type of solution:
1) The 13b engine tension bolts (and by extension the Renesis bolts as
well) have been known to fail in aviation applications simply from
vibrational fatigue. This is acceptable (in so far as the engine
keeps working) when the engine has forward and aft mounts. In the
cantilever mount approach, I wonder whether we would see accelerated
failure of the tension bolts & am concerned about the in-flight
consequences of the tension bolts letting go like a zipper.
2) The front cover (aft in aviation install) is not attached via the
tension bolts, but rather through a series of taps in the end housing.
All the tension from the cantilevered engine (6g hard landing), as
well as the torsional loads from the engine making power will be
concentrated here. Even assuming one increases the size of the end
housing to incorporate the pads for the water pump, I wonder whether
these (2cm deep?) taps would be up to the job over a notional 2000 hr
tbo.
Interested to hear your thoughts.
Mark (Rocky Mtn High)
I agree with you and the MM loads are real high. The Lycoming
engine itself is obviously designed to take the loads.
In Mistral's case they are making all the engine parts
so they have the opportunity to beef them up to take
the cantilever engine loads if a problem appears. In the case
of the Le Mans race cars, where the engine was a stressed
member of the chassis, carbon fiber sandwich plates were added at the
top and bottom of the engine to beef it up.
Since Jerry built your mount we have gone to an asymmetrical MM design
giving more room in the engine compartment for cooling systems.
The water rad can now be mounted vertically on the cool side of the engine
and a larger oil cooler underneath.
In your case here are some suggested improvements to your oil
cooling system that can be done with out major changes.
I think these changes will be a major help.
Don't worry about the drag of the cowl flap
when open. It will have near zero effect on the climb
rate. Climb rate is 90% power to weight ratio.
1500 FPM climb is 25 feet per second straight up.
25 times the gross weight of the airplane is the
net HP out of the prop needed to lift that amount of weight.
The net HP is therefore 50,000 pound foot per second
or 90 HP out of the prop alone not counting induced drag
due to lift just to lift the weight of the aircraft.
At best the prop is 80% eff. so that means
you need 112 HP out of the engine just to lift the
weight of the aircraft. At your density
altitude your engine is down on power to about
75% so total engine power is about 187 HP.
Net out of the prop is only 150 HP at your density
altitude.
BTW There is nothing that can be done about induced
drag due to lift short of increasing the span.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.