Hello Paul & Group,
I have been surfing the Internet for two days now, and have made a gazillion phone calls
to different suppliers trying to locate someone that can supply me with a 2 3/4" 321 SS
180 degree bent tubing .065 or heavier for my 6 port Renesis engine exhaust system. The
heaviest 180 degree bent I can find is .049 in 321 SS, but I don't think that is thick
enough. Does anyone out there know of a supplier that I can get this from? I'm planning
on using my stock exhaust manifold. I have already cut the down turn part off so I could
weld the SS to it. I'm open to any suggestions, my head is getting sore from banging it
against the wall.
Thanks.
Bob Forbes
Bush Caddy L-164
Burns Stainless 321 has 3 inch OD 90 degree. 16 Gage is .065.
http://www.burnsstainless.com/90degreebends-3.aspx
Why so big? 180 degree takes a lot of force to extract
the mandrel. You will need to make it out of two
90's.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.