Does anyone remember which Toyota water pump was used as a remote water
 pump for the 13b?  I need to mount the pump done low as there is little
room
 at the stock location and cowling prohibits the Mazda pump. Thanks for any
 help.

 Joe Berki
 13b P port


 Ask me in a couple of weeks Joe and I can search old messages.

 Paul Lamar From Germany



Here's what I found fishing through my newsletter archives:

Mark (Rocky Mtn High)
Total flights on PPort engine:  2
Total flight time on PPort engine:  1 hr


============================================================================
============================

Hi again Doug and Joe B,
the best we can identify the pump as an AE92;   it came off a Corolla,
 4AGE, 1600cc engine.



============================================================================
=============================

Hi All,
for a pic go to Aust Ebay,   Ebay .com.au and look for Toyota parts 4A
GE water pump.
This remote pump was used on all Corolla engines 88 thru 92.  2C,
single cam 2 valve, and,  twin cam 4 valve engines 4A FE and 4A GE.
FWIW, Dave McC

============================================================================
=============================

Here is the Corrola pump mentioned above.



#G3000-45470    Water Pump W/ Housing
       ASCO/Aisin (OEM)        $71.51

Vehicle:
1992 Toyota Corolla 4Dr Sedan

Fits Engine - Chassis:
4AFE --- AE92

Description: W/ Housing

Year: 8/1989-9/1992

-------------------------------------------

The Corrola is a small engine of about 100 HP.
You need about 30 gallons a minute as I recall at
around 6000 RPM. Don't forget to put back pressure
on the pump when you are testing it.

Paul Lamar


============================================================================
===========================

Hi Paul and Doug,
had a long discussion with Don Dunbar about the data we collected
with the Corolla 4A FE pump.
The test data was : pump driven by electric motor at 3000 rpm,
pumping thru the 13b block.
Results: Output of just over 100 liters per minute
[26 gallons per minute] maintaining head
pressure of 1.5 meters [60 inches of water or 2 psi].

[12 inches of water is about .45 psi]

The pump pictured in Autoparts Warehouse looks identical.  I said
previously, in error, that it was from a Supra, it may well be fitted
to Supra engines, but it is OEM on Corolla engines. At present, I just
happen to be replacing the head gasket on my son's 4A FE Corrola and it
is that pump for sure.
Hope this gives you the info you need,
BR, Dave McC


2 psi is not much back pressure Dave.
http://www.onlineconversion.com/pressure.htm

See Bill Schertz charts for the stock Mazda pump.

Paul Lamar

=======================================================================

Thank you very much!!

Joe