Why yes; yes it does...
While investigating our poor oil cooling performance, I disassembled
the stock RX-7 oil cooler to confirm the bypass port was properly
closed. Imagine my surprise when I looked into the oil intake port
and saw what appeared to be a large amount of foreign metal coiled up
in the port. I reached in with a pair of needle nose pliers and
proceeded to remove eight 1/2"x18" metal strips in varying degrees of
jumble inside the intake port. (photos below)
After inspecting them, it became clear to me what these were.
Apparently, these were inserted into the oil tubes and served to
turbulate the oil as it flowed down each tube. No doubt to increase
heat transfer & prevent laminar flow/boundary layers from forming. In
our installation, we had oil flowing into the outlet, and out of the
inlet. This apparently dislodged these turbulators, and allowed them
to fold up within the port area at the end of the cooler. Not only
was no turbulation happening, but no doubt flow was restricted by all
the tightly jumbled metal.
I spent 15 minutes or so carefully removing all the turbulators (there
being no way to reinsert them).
My question to the group: Is this oil cooler now officially shot?
Does the lack of these turbulators render the cooler useless? Our
intent is to go ahead and reassemble it and give it a try -- the
resulting cooling can't be any worse than we've been seeing after all.
Mark and Terry (Rocky Mtn High)
New one on me. What weight oil are you running? Did you start it up
on a cold day?
I think it is shot.
Paul Lamar
I have maybe 30 rx7 oil coolers I collected for use with early porsche 911
engines for high performance use. There are many of these coolers on 911s
because they are cheap compared to the real race units. To use them for the
cars we removed the alum mesh to allow better flow since 911s use a dry sump
and low pressure oil circuit to the cooler, and the mesh would be too
restrictive.
Your cooler will work much better now after you removed the mesh, but test
it for your purposes. The mesh does undoubtedly collect more heat with the
high pressure circuit of the rotary oil system. The flow rate will be lower
with the mesh.
We used 2 to 4 of these coolers on each car, depending on engine power,
and ambient temp at the track. Pre 1999 911s did not use glycol coolant to
get rid of the heat. Oil and cooling fins were it. No water. Just like the
flat 4/6 aircraft engines I guess.
Ed Carver