In a message dated 4/16/2010 11:21:23 PM Eastern Standard Time,
rotaryeng@earthlink.net writes:
At Al...
Paul said vertically (seal on end). I double took at that as well.
[A quick check is insert an apex seal vertically and make sure it does not
move back and fourth more than 3/8th of an inch at the top.]
Michael S. Francisco
That is just a quick check to see if the rotor is junk. No more than 3/16"
The clearance for iron seals is .0020" to .0035" Snug check with a feeler
gage.
The thinking is that as long as the groove is uniform end to end with
little taper, the wider of the widths is fine. The tapered groove is thought to
produce chatter marks and that accelerates wear.
A 2MM groove rotor can be machined to fit a 3MM seal. Check the fit of the
corner seals before spending the money.
Lightly damaged grooves, where a piece of scrap has made a gouge track
closing up a bit of a groove can be repaired with small files laid in the length
of the groove with some heavy oil so the file works only on the damaged
area. You can load the file over the damage site with a pic or even a tiny
screw driver. A bit of work can save an otherwise perfect rotor.
Before you finish place your clean fresh rotor between aluminum plates and
give the gear a good hard push in a press. To be sure the gear is in the
bottom of the well and has not walked out any at all. This can happen during an
overwind or missed shift. Not a problem under 9,000 RPM.
If you install a new bearing, grind the alignment tang off completely
first. Use the factory tool or similar to push the new bearing.
Lynn E. Hanover