Why yes; yes it does...
While investigating our poor oil cooling performance, I disassembled
the stock RX-7 oil cooler to confirm the bypass port was properly
closed. Imagine my surprise when I looked into the oil intake port
and saw what appeared to be a large amount of foreign metal coiled up
in the port. I reached in with a pair of needle nose pliers and
proceeded to remove eight 1/2"x18" metal strips in varying degrees of
jumble inside the intake port. (photos below)
After inspecting them, it became clear to me what these were.
Apparently, these were inserted into the oil tubes and served to
turbulate the oil as it flowed down each tube. No doubt to increase
heat transfer & prevent laminar flow/boundary layers from forming. In
our installation, we had oil flowing into the outlet, and out of the
inlet. This apparently dislodged these turbulators, and allowed them
to fold up within the port area at the end of the cooler. Not only
was no turbulation happening, but no doubt flow was restricted by all
the tightly jumbled metal.
I spent 15 minutes or so carefully removing all the turbulators (there
being no way to reinsert them).
My question to the group: Is this oil cooler now officially shot?
Does the lack of these turbulators render the cooler useless? Our
intent is to go ahead and reassemble it and give it a try -- the
resulting cooling can't be any worse than we've been seeing after all.
Mark and Terry (Rocky Mtn High)
New one on me. What weight oil are you running? Did you start it up
on a cold day?
I think it is shot.
Paul Lamar
Sorry for the improper format in my previous reply.
Forgot to mention, it is necessary to cut off the end tanks to get the
mesh
out. Yours may have an oil thermostat on one end.
Ed Carver
Mark, what is the status of the oil cooler. Are you going to replace it
with another RX7 cooler? I cannot for the life of me figure out what
happened. Either the cooler was not brazed properly or near solid
cold oil forced the turbulators out of the tubes under the influence from
the oil pump. Highly unlikely. For those brazed joints to fail it took a
lot of force. First time in eleven years I have heard that happen.
Perhaps the lack of the oil thermostat had something to do with it.
When the oil was cold it was more or less solid. What weight
oil are you using? 5 W 30 or some such should be used.
Paul Lamar
Paul -- we have seen this on a few coolers over the years.
Dave Lemon Mazdatrix
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.