Hi Paul & Group -
Is it in the public domain how mazda sealed the lemans periphiral ports to
the
outside of the rotor housing? Are your sealing caps copied from that engine
?
Fly & Build good -
Bryan Wilkinson in Un - grounded England
Mazda sand cast special p-port rotor housings for racing.
Very expensive.
Paul Lamar
Paul,
Any chance you have the dimensions of the D ports in those special castings?
Can't quite see the exhaust shape in the pics.
Thank you!
Ed Carver
Don't have them Ed. Rather radical timing for 10,000 RPM or more.
Paul Lamar
Is the D shape beneficial for our use in an aircraft engine? Or can it
simply not work reliably? I have read nothing on this issue. As soon as I
learned about P porting, I considered D shape. But had no reference to
usage. Too dangerous to try when round works well enough?...
Ed
It will work but it gives very little additional HP at 7500 RPM.
It is mainly designed to work at up to 11,000 RPM for racing
purposes for every last HP that counts. The big draw back
is it makes building the p-port rotor housing far more difficult
than merely welding in a new tube which is what we are now doing.
It is just not cost effective for our purposes.
Paul Lamar
Are the dimensions of the D equal or larger than the circular port on
the exterior of the housing?
If so, I don't think it would be too tough to make the D shaped port..
Need a mandrel on which to shape the rotor end of the tubing.
And a projection of the D shape onto the wear surface. Print that
onto a sticker. The sticker should have a couple of alignment marks
on it including a center point.
- Use a hydraulic press to force the stainless tubes onto the mandrel.
- Bore a small pilot hole through the housing, through the wear surface.
- Put the sticker onto the wear surface - aligned with the pilot hole.
- Bore the housings as normal.
- Trim the material out to the D as indicated by the sticker. Check
as you go with the mandrel formed tube.
- Weld the formed tube to the wear surface.
- Cut the tube flush with the wear surface.
- Blend to a nice shape. Correct leaks.
I agree that it's not worth the extra effort for aircraft use..
Matt-
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.