Subject: Mazda Lemans , P Port sealing
From: Rotary Engine
Date: 4/22/2010, 10:37 PM
To: AAA Put this in the To box


 Hi Paul & Group -

 Is it in the public domain how mazda sealed the lemans periphiral
ports to
 the
 outside of the rotor housing? Are your sealing caps copied from that
engine
 ?

 Fly & Build good -
 Bryan Wilkinson in Un - grounded England

 Mazda sand cast special p-port rotor housings for racing.
 Very expensive.

 Paul Lamar

 Paul,

 Any chance you have the dimensions of the D ports in those special
castings?
 Can't quite see the exhaust shape in the pics.

 Thank you!
 Ed Carver

 Don't have them Ed. Rather radical timing for 10,000 RPM or more.

 Paul Lamar

 Is the D shape beneficial for our use in an aircraft engine? Or can it
 simply not work reliably? I have read nothing on this issue. As soon
as I
 learned about P porting, I considered D shape. But had no reference to
 usage. Too dangerous to try when round works well enough?...

 Ed

 It will work but it gives very little additional HP at 7500 RPM.

 It is mainly designed to work at up to 11,000 RPM for racing
 purposes for every last HP that counts. The big draw back
 is it makes building the p-port rotor housing far more difficult
 than merely welding in a new tube which is what we are now doing.
 It is just not cost effective for our purposes.

 Paul Lamar




Are the dimensions of the D equal or larger than the circular port on
the exterior of the housing?

If so, I don't think it would be too tough to make the D shaped port..

Need a mandrel on which to shape the rotor end of the tubing.

And a projection of the D shape onto the wear surface.  Print that
onto a sticker.  The sticker should have a couple of alignment marks
on it including a center point.

 - Use a hydraulic press to force the stainless tubes onto the mandrel.

 - Bore a small pilot hole through the housing, through the wear surface.

 - Put the sticker onto the wear surface - aligned with the pilot hole.

 - Bore the housings as normal.

 - Trim the material out to the D as indicated by the sticker.  Check
as you go with the mandrel formed tube.

 - Weld the formed tube to the wear surface.

 - Cut the tube flush with the wear surface.

 - Blend to a nice shape.   Correct leaks.


I agree that it's not worth the extra effort for aircraft use..


Matt-


AT Racing Beat I noticed the P-port has a noticeable curved upper lip
for a softer blend into the chamber...they install the port slightly
different, probably more difficult but it has a nice transition  that
may keep turbulence down.....

Working with the stainless tube, you realize how soft it is..it could
be, with the proper machined port shape, carefully soft peened and
curved up enough to give a similar form.....not sure if there any
benefit to this idea for our purpose,

but that sharp and abrupt edge may be improved.......just a thought.....

jeff


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.