Subject: Apex seal break in and the Atmel computer
From: Rotary Engine
Date: 5/17/2010, 11:26 AM
To: AAA Put this in the To box

You hear people say that after market apex seals
need breaking in. Mazda apex seals need no
breaking in as they are properly crowned
to fit the rotor housing from day one.
There is no break in period on the RX8 car
or engine.

This can be seen in the compression pressure
if you have a way of accurately measuring it.

Normally Mazdatrix uses a special tool/recorder from Mazda
and after market tool companies that cost hundreds of dollars.

http://rotarydiagnostics.com/pricing combined.htm
http://www.asashop.org/autoinc/dec98/techtips.htm

Mazdatrix built an engine with after market apex seals despite
their reluctance to do so. Sure enough initial compression
pressure was down 5 to 10%. This translates to a similar
loss of HP. What worse is the break in process results
in damage to the expensive rotor housings because the
after market apex seals are much harder than the special
cast iron and manufacturing methods Mazda uses.

This has little to due with wear of the apex seals as
the Mazda seals are super smooth as are Ianetti
silicon nitride ceramic seals that do not appear
to wear at all.

We now have a low cost way of recording the compression
pressure curves using the Atmel computer. One can verify
these facts. Furthermore one can measure the health
of one's rotary engine over time just like a compression test
is part of the annual inspection required of certified
aircraft engines.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.