Subject: Schematic for the RPM board
From: Rotary Engine
Date: 6/5/2010, 11:58 AM
To: AAA Put this in the To box

Four cheap chips on PC board
1.25 inches high by about 3.8 inches long.
Estimated PC board only cost $15.

The 555 osc allows the fly wheel pulse to increment the
counter for about (adjustable depending on how many teeth
on the fly wheel) .6 seconds and then sets a bit
in a latch. The ZBasic program polls the stored bit from time
to time and reads the RPM when it feels like it.
Then it resets the counter, the stored bit and re enables
the RPM counter.

------------------------------------------------------------

7500 RPM is 125 revs per second.
100 pulses per rev is 12,500 pps.

The count of interest is 7500 RPM.
That is 125 CPS. Assume 100 teeth on
the flywheel so that is 12,500 PPS.
So 12,500 pps X width = 7500.
So width = 7500 / 12500 = .6 seconds.
That is the count time.
That translates to 1.666 CPS.

Since we have a spare 4520 divide by 16 counter left over
the 555 osc frequency can be 16 times that or 26.656 cps.

Here is a chart for the 555 free running frequency
verses the resistor and capacitor values.

Looking at this chart 100K resistors and a .5 mfd
capacitor will put the 555 oscillator in the ball park.
The pot will make the final adjustment.


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.