On the Speed Channel right now.
No less than seven RX8's are entered.
4 Corvettes, 2 Camaro's... (your tax dollars
at work) 2 Porsches and 1 BMW.
The RX8's are hanging back... plenty of hours
to go. They don't want to dominate as they
might be handicapped yet again.
Interesting that the 911 like Porsches are having
trouble with rear tire over heating. One would
think they would have this problem solved
over the last 50 years.
The Corvettes are carrying at least 100 pounds of
ballast. If it were not for handicapping, the
Corvettes would run away with this race due
to 5 liter motors while the RX8 is 3.9 L and
the Porsche 3.8 L. The street car price
difference is enormous. $35K for an RX8
$65K for a Corvette and $100K for the Porsche.
The RX8 is too cheap :)
Same goes for engine overhaul cost as
the Mazda rotary can probably run as many as 10 races
while the piston engines will probably need
overhaul after this race. My guess is a race Chevy
engine could be around $50K while you are
looking at close to $100K for a Porsche racing
engine. The 3 rotor RX8 engines can be over
hauled at $8K.
The reason race piston engines
cost so much is the non stock expensive materials
used. The RX8 motor is 95% stock street car materials.
Only the apex seals are ceramic.
No need for expensive materials as the stress
on the rotary engine parts is much lower. Another
factor is the race rev limit on the RX8 engines
is 500 RPM ==== BELOW ==== the stock street car!!!!!!
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.