The RX8 trigger signal and wheel is unsymmetrical so it
takes a storage scope to see the whole picture.
A very good friend had an extra (what was) a high buck
Tektronix storage scope and donated it to me
for use on the news letter. Here is a better
representation of the what the RX8 trigger signal
looks like. You can clearly see rotor one
and rotor two.
Paul Lamar
Paul,
What gap are you using for these scans? Also, can you determine the minimum
rpm to get a signal?
Mark S.
It is .2 inches.
I am running the router motor as slow as it will go
and the RPM looks like 5000 RPM.
Vertical divisions are set to 2 ms on the scope.
You can twirl it with your fingers and get a weak signal.
My guess is you would get a signal at a couple
of hundred RPM. My half inch drill motor goes
down to 1380 RPM and one still gets a very strong
signal from these things.
I would not worry about that. Are you sure you have
a good pickup? It could be damaged.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.