Here is what I have for mounting and sealing to the slide throttle.  It is a
clamp that is split and pressure applied via two screws to hold it to the SS
tube.  A ring with a O ring is held in place and pushed up against the slide
throttle side plate when it is all bolted together.  I had to do it this way
because there is no room for hoses and I wanted the slide throttle as close
to the ports as possible.  Is there a tool available to bead 2" diametet
aluminum tube?  I will need it up stream from this.  Paul, I have been
following the injection and ignition threads and it sure looks promising.
Can't wait to see it run.  Thanks for any help

Joe Berki
Limo EZ

Did you sand the anodize off of Doc's slide throttle?
It's OK I just wonder why.

Paul Lamar