Paul,
          I give up, just how are you intending to fasten
the muffler to the manifold slip joint ??  Any solution
I think up adds a lot of weight.  The design is actually
impressive, simple and as light as p[ossible.,
  I can only get 316 stainless here, but the simplicity
means that I can make two with one as a spare.
             Neil.

Two small vertical tabs and a horzontal link with a couple
of six mm SS bolts and SS nuts. One tab on the muffler and the
other on the flange stub. Another way its been done
is a small spring but I suspect the temper will go away
sooner rather than later. Even several loops of heavy
safety wire will work.


  _     _
 |o|   |o|
___| |___| |____
     |

This is SOP in aviation.

The link with bolts is the best.

The slip joints allow a bit of expansion and
contraction due to differences in temperature.

One link at the center exhaust port will work
but I would put three on there in case one failed.

BTW there is an old book still for sale by
the EAA called "Fire Wall Forward" by Tony Bingelis.
It is sort of the bible for piston engine AC installations.
Well worth it. Here is a graphic from it.


Paul Lamar

Looking at the graphic, it seems that a better
seal or containment of the exhaust gasses would
result if the flow direction was reversed.

Joel

I agree but who am I to argue with Tony Bingelis :)

Paul Lamar