Here is what I have for mounting and sealing to the slide
throttle. It is a clamp that is split and pressure applied via
two screws to hold it to the SS tube. A ring with a O ring is
held in place and pushed up against the slide throttle side
plate when it is all bolted together. I had to do it this way
because there is no room for hoses and I wanted the slide
throttle as close to the ports as possible. Is there a tool
available to bead 2" diametet aluminum tube? I will need it up
stream from this.
Paul, I have been following the injection and
ignition threads and it sure looks promising. Can't wait to see
it run. Thanks for any help
Joe Berki
Limo EZ
Did you sand the anodize off of Doc's slide throttle?
It's OK I just wonder why.
Paul Lamar
Paul,
The clamp plates in the picture are not the same plates, I had to turn them
to accept the ring that carries the O ring. The side plates were not
anodized.
Do you know how I can bead 2" thinwall tubing?
Joe Berki
Limo EZ
http://www.tubebeadingtool.com/
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.