I just figure out how to have an entirely
separate system on the trailing plugs
for back up. Just use a stock 2nd gen waste spark
coil module and two magnets on an outer
ring like Klaus does. One Hall Effect
sensor is all you need to trigger
the stock 2nd gen inductive waste spark
coil module. The coil switching transistor is in
the stock module. Here is a picture. Won't work
on a 3 rotor however.
Normally the eng control computer fires this coil around
22 degrees BTDC and then 180 degrees later. The computer
calculates the 180 degrees but the second magnet
mounted 180 degrees away will do that job automatically.
The ballast resistor will fail if you cruise at high
RPM so it needs to be swapped out for a higher
wattage resistor. Super simple.
In fact if you wanted to you could use both modules
with one Hall Effect sensor and have an entirely stand
alone ignition system for use with a carb.
No computer required. No PC boards, nada.
No fancy anything.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.