Subject: Dealing with just the trialling plugs.
From: Rotary Engine
Date: 7/2/2010, 9:42 AM
To: AAA Put this in the To box

I just figure out how to have an entirely
separate system on the trailing plugs
for back up. Just use a stock  2nd gen waste spark
coil module and two magnets on an outer
ring like Klaus does. One Hall Effect
sensor is all you need to trigger
the stock 2nd gen inductive waste spark
coil module. The coil switching transistor is in
the stock module.  Here is a picture. Won't work
on a 3 rotor however.

Normally the eng control computer fires this coil around
22 degrees BTDC and then 180 degrees later. The computer
calculates the 180 degrees but the second magnet
mounted 180 degrees away will do that job automatically.

The ballast resistor will fail if you cruise at high
RPM so it needs to be swapped out for a higher
wattage resistor. Super simple.


In fact if you wanted to you could use both modules
with one Hall Effect sensor and have an entirely  stand
alone ignition system for use with a carb.
No computer required. No PC boards, nada.
No fancy anything.

Paul Lamar

Paul,
I don't think you can get away with wasted spark on the trailing plugs.
Leading plugs ok, but not trailing.
The ideal way is using the coil on plug technology. The coils are small and
light, and respond to multi spark very well.
Added benefit is no plug wires....
Larry

You are right. The 2nd gen RX7 waste spark coil unit is used on the Leading
plugs and not the Trailing plugs as I stated above. Two coils must
be used one for each rotor. The same scheme will work however you will just
need two HE's instead of one looking at the magnet wheel. One of the
magnets and HE's will be on a different radius. Front rotor rear
rotor.

As I recall waste spark is not good for the trailing plugs
as the non active rotor is in contact with the compression
chamber that contains fresh mixture that might pre ignite
and back fire through the intake.

Thanks for catching that Larry.

BTW I need a coil on plug unit
that does not have a transistor in it for the Leading plugs.
Do you know of any? Two old fashioned coils will work fine
but they are large and heavy and over kill for just one
spark plug. Perhaps from a motorcycle or out board motor
with CD ignition systems.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.