I'd be interested in Jeff's unit....but that is a lot of work to adapt it
to
a 20B! Does Jeff make a unit to adapt the stock 20B pump?
Jeff?
Marc Wiese
I don't see the advantage Marc. What do you hope to achieve?
Paul Lamar
Marc,
The two main reasons I went ahead and converted my 20B to the Renesis WP was
1) a 7 lb. weight savings, and 2) my 20B cartridge developed a leak. If you
haven't tackled the wp/alternator installation yet, it probably wouldn't be
that much additional work.
To start with, you would need to obtain a Renesis front cover and wp
cartridge, get the front hub and pulley set while you're at it. Then cut
the wp section off on the band saw. Keep the WP section and throw the rest
away. Order Paul's "Renesis WP adapter", some wiggins couplings, and 6 ea -
6mm x 110mm studs from McMaster-Carr. You're almost there...
I used the stock crank pulleys but ordered an aftermarket (std. dia.) wp
pulley and an over-sized (4" dia.) alternator pulley from Canton Racing. If
you're wondering why I didn't use the 20B wp pulley, it is smaller and has 8
bolts where the Renesis has only 3.
CAS bracket was made from a piece of 1/8" x 2" x 3" angle (you want it very
stiff so you don't get any vibrations). If you're using the old style CAS,
you won't need to do this.
Mark
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.