Well done Don, sounds like you done real good.
John
Hi Guys
I thought you all would appreciate this posting.
I sold my Citabria and bought a Piper Arrow last winter and have been doing
IFR training in it. This evening departing Madera, at about 700 ft agl the
engine came apart? Retracted the gear then backed the throttle to climb. At
that point the engine started shacking like a dog passing a peach pit. It
had a dead miss but worse. Thought I shot a piston but the cowl didn't have
a hole in it. I didn't get a chance to check the manifold pressure after
that but it was making some power. Pitched for an airspeed of about 100.
Checked the fuel pump and advanced the throttle. Shacking was getting worse.
Windshield started covering with oil. Design time was at hand. She was still
making some power so I started a 10 deg bank to the left to alien with a
road. Madera has a restricted ag strip that's aligned about 30 degrees from
the main strip. Figured I could turn back the 150 degrees to the ag strip so
that's what I went for. I was making about 80 mph and a 600 ft pm sink with
full throttle. Made the pavement after a VERY short and INTENSE approach. I
was on an IFR flight plan so I got to declare an emergency. Landed with a 30
deg. Cross tail wind at10 kts. Density altitude was plus 1800 ft field
elevation.
Got is shut down and found a rod and wrist pin in the cowl. The bottom of
the case has a hole you could stick your head in and wiggle your ears.
My wife told me I'm a real pilot now. Survived a crash landing without a
scratch.
Could have been worse. I could have been over the wastelands of Nevada or a
12,000 ft. over the Sierras
Thanks
Don Williams
MKIV Madera
Paul,
I realize that our group is dedicated to the rotary, but I thought that you
might find this of interest. The plane that I started to construct, until
it was deemed that I should contribute to the California unemployment
statistic, was a Christivia IV.
This presents another great argument for the rotary. . . Would I be amiss
to state that the rotary in comparison to a piston engine has less of a
probability of catastrophic failure?
Regards,
Gordon
Certainly less of a chance of a catastrophic engine failure in the
hand grenade mode but you do have to pay close attention to fuel and
ignition issues as well as cooling details.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.