Subject: P-port Flight Report - 7/16/10
From: Rotary Engine
Date: 7/17/2010, 5:59 AM
To: AAA Put this in the To box

Paul,

I flew my p-port 3-rotor Lancair ES on Friday.  OAT was about 90*F, but
coolant stayed below 200 during climb and oil temps were 185*F max.  The
p-port engine ran great, except for a little mis-firing around 5700 rpm,
which was corrected in flight with auto-tune.  Pre-takeoff run-up gave a
brief excursion to 6900 rpm.  Takeoff run was 6500, running very well, but
limited by prop setting.  It started to misfire when I dialed the prop back
for cruise-climb, so I cranked it back up to 2000 (prop) and it ran smooth
again.  Once at 3500 and leveled off, I entered auto-tune and brought the
rpm down to the 5700 range and let the EM-2 tune the EC-2, map addresses 90
- 92.  Afterwards, it ran great throughout the rpm range.  (I had
"auto-tuned" much of the upper map range on the previous flight.)

At 3500 - 4500 MSL, the EFIS was indicating 172-174 TAS at 1800 rpm prop
setting, and 201-203 mph per the EM-2.  This is consistent with a previous
test run I had recently done and represents a 12-14 knot improvement over
the side-port motor.  The cool thing is that these speeds are in "economy
cruise" mode.  Engine was just purring along at 5500 rpm.  There should be a
bit more speed on the table as I realized after the flight that I had never
closed the cowl flap.  ;-)

Later on, I will run it a bit harder, around 6500 rpm, and see how she
performs.  But the vast majority of my flights are in the 5200 - 5500 rpm
range.  So, this is very good news.

Mark

Yes it is Mark and you are now the current chief P-port pioneer
replacing Everett Hatch and Steve Beckham  of old Power Sport.
Also the first person to fly a P-port 3 rotor I suspect. You
are also the first person to successful fly a slide throttle
as well. (I don't count crashing the airplane on landing a
successful flight :))

Congratulations. I suspect Tracy's EFI system is being put to the
test. It is one thing to get it to work with a fixed pitch prop and
quite another to get it to work with a variable load, constant
speed prop.  I suspect it could use a bit more sophisticated
power monitoring  system than just a MAP and air temperature
sensor. Perhaps a MASS air flow sensor would make it easier.

I need some pictures of your cowl flaps and the new cooling
system.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.