Subject: How do I wire this to a Dynon D-180?
From: Rotary Engine
Date: 8/11/2010, 7:40 PM
To: AAA Put this in the To box

  Hi All,

  Has anyone thought through how to wire the stock RX8 coolant
  temp sensor to a Dynon GP Input? Any info on specifics of
  the sensor is also appreciated.

  Thanks in advance,
  --Kenny A.

  Do you have the instructions for the Dynon Kenny.
  You need to know what kind of sensor it requires.
  You also need a calibration curve for that sensor.
  Resistance verses temperature.

  The ECT Engine Coolant Sensor in the RX8 is the thermistor
  type.

  "Thermistors are thermally sensitive resistors whose prime
  function is to exhibit a large, predictable and precise change
  in electrical resistance when subjected to a corresponding
  change in body temperature.  Negative Temperature Coefficient
  (NTC) thermistors exhibit a decrease in electrical resistance
  when subjected to an increase in body temperature and Positive
  Temperature Coefficient (PTC) thermistors exhibit an increase in
  electrical resistance when subjected to an increase in body
  temperature.  Because of their very predictable characteristics
  and their excellent long term stability, thermistors are
  generally accepted to be the most advantageous sensor for many
  applications."

  I am not sure if the RX8 is a PTC or NTC type. Use an ohm
  meter and place it in boiling water. You can then calibrate it
  and compare the calibration curve with the Dynon type.

  Paul Lamar


 Automotive ECT's are negative. The lower the temp, the higher the
 resistance.
 This allows less current to flow and the ECU "see's" higher voltage. This
 richens the mixture like a choke. As the coolant warms, the resistance
 gets
 less. The ECU see's less voltage, thus less fuel. On the ECU board
 there are
 resistors just before the terminal to the sensor. There is an internal
 take
 off for it to sample the voltage, between this resistor and the sensor.
 Test to your heart's content though.

 Dale Davies

 Dynon does not publish a spec for their sensors. Their GP sensor is the
 same as their oil temp sensor. If you bought the sensor package and have
 the oil sensor, compare it to the RX-8 for resistance vs temp.  If they
 are not the same, it is unlikely you will be able to rig to get accurate
 readings.

 Victor

Thanks all, this is plenty to get me started. Attached is
an excerpt from the installation guide. Looks like the
right combination of voltage divider / gain and anything would work.

--Kenny A.

That is pretty blurry Ken. Can you scan it at higher
rez?

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.