Subject: Mark Suspinski crash and fire.
From: Rotary Engine
Date: 9/12/2010, 3:49 PM
To: AAA Put this in the To box



In my opinion fuels pumps belong in the fuel tank,
either the mains or collecting header tank.

Doug in Japan




Which means in my plane that a 'high-pressure' line will be running through
the cabin (RV-6) instead of a suction line.
Not sure I really like that...

BrianG
Iowa


Excellent point. Thanks for bringing that up. I almost
crossed over to the other side.
C. Smith

The point is that you could run a thick steel line through
the cabin area. If you break that you have other problems.
Bill Jepson

All fine and dandy, steel fuel line, more robust, also need to
buy tooling and fittings. Increased cost. I also have a 4 tank
system, likely that the fuel selector valve will be located in a
structure below the cabin. A leak in a suction line typicly
draws in air, not spray out fuel, until the pump is shut off.
Then it becomes a small dribble (depending on size), hopefull
the now leaking fuel will be smelled by the user during
preflight on the next use. Also a steel line can be affected by
vibration fatigue, although not a likely concern with a rotary.


C. Smith


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.