Subject: PLANET GEAR REDUCTION DRIVE FOR TWIN PROJECT
From: Rotary Engine
Date: 9/24/2010, 6:03 PM
To: AAA Put this in the To box




 Hi Paul
 I finish to renovate my new house and ready to go back on my project.
 I will stay with p port intake and install turbo but i want to built my own
 drive with ford diezel trans 5R110W planet gear system.
 the gear system is bigger then the E40D WITH RATIO OF 2.48.-6 pinion planet
 system Drum size 5"+
 I look on the Slauson catalogue but i found a better price on EBAY

 I intend to cruise at 6200 rpm approx and i would like to know the HP at
 this rpm for rx-8 pport and turbo.
 i will also appreciate your comments


 Jean Prudhomme

 I think that gear set is overkill and too heavy.
 Several people have used the A4OD set with three rotors.
 One with a turbo 3 rotor. The ratio is not as good
 as it is only 2.48 rather than 2.85.

 Send me a dwg of the rest of the gear box.

 The HP you get will depend on the boost. The fuel
 burn will determine that at cruise. Figure a half pound
 of fuel burned for every HP you choose. Fuel weighs
 about 6.25 pounds per gallon.

 P-port 2 rotors have been easily boosted to 400 HP
 or more. Obviously you don't want to burn that much
 fuel at cruise.

 Paul Lamar

 Jean,  You need to devide your cruise RPM by your planet gear ratio to see
 what propeller RPM corresponds to that engine speed.Each planet set has two
 speeds depending whether the ring gear or the planet carrier is being held.
 Holding the planet carrier reverses rotation.


I am attaching some pictures
 of the three planetary gear sets from the 5r110w transmission. As you can
 see two of them are 4 planet gear carriers with only the front being a six
 pinion design. 4 pinions have only 2/3 the number of teeth in contact and
 therefore less torque capacity than an equivalent diameter six pinion unit.

 It is also necessary  to look at how you can attach input and output shafts
 to the gear set. I downloaded these pictures from e-Bay. They are relatively
 inexpensive to purchase there so you might just buy one to get a good look
 at it and to measure for designing the housing. I have also inclused an
 illustration view of the 5r110w so you can see how the stock input and
 output shafts are configured.


Any parts you can use as is or modify by
 cutting off excess length are a plus in choosing a planetary set different
 than the E4OD. I have chosen a transfer case planet set because due to being
 after the main transmission they have to handle the low gear torque
 multiplication of that transmission. Also the transfer case planetary is
 little used as it is only engaged in four wheel drive low-lock operation.
 The other consideration is the ability to have a larger diameter or hollow
 output shaft for a constant speed prop.


george grimes

The front planet alone gives you the needed 2.85:1
and is used in the Ford Power Stroke diesel pick up
truck with 650 foot pounds of torque.

The P Port rotary is 200 foot pounds and a 350 HP turbo rotary
would be about 300 foot pounds max.

I agree with Petri the box needs a separate oil supply
with the proper type and a cooler.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.