Subject: Speaking of rotary engines
From: Rotary Engine
Date: 9/26/2010, 11:58 PM
To: AAA Put this in the To box


Speaking of rotary engines, may I throw out some questions?

1.  Any 'crate' 3-rotors available?  If used only, how hard are parts
to find
    and how long will they be around?
2.  Are 3-rotors inherently smoother than 2-rotors?
3.  Wouldn't a 3-rotor be less "bulletproof" than a 2-rotor if for no
other
    reason than they must have either split eccentric shaft or split
    bearings [ala German version]
4.  Would the 16X version be superior for our uses?
    [I haven't seen any production versions of the 16X 2-rotor, but
the
    direct fuel injection sure would be nice.  But with a longer
"stroke"
    the power pulses would be larger than with a 13B, although the
    exhaust gas temp should be lower, and it should yield higher HP
    at lower rpm.]

Gene Kahn, casual but interested observer

1. Don't know but as long as rotor
housings are available from Mazda the rest of the parts
are easily made by second parties.

2. Yes. 3 power pulse per rev as opposed to just two.

3. The e-shafts never gives any problems. As long as
there is fuel, spark and oil pressure nothing
gives any problems. No exhaust valves to burn, no rods
or any other parts to fail. There should be an article
in Kitplanes shortly called the rotor verses the piston.

4. IMHO no. There is no advantage to low RPM torque.
for A/C use. Torque is controlled by the gear box so the
only thing that matters is HP to weight ratio and the 16X is
no lighter than the current RX8 engine. Yes you
may get more HP but so too fuel burn if you take
advantage of it.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.