Subject: sun gear attachment to input shaft.
From: Rotary Engine
Date: 9/29/2010, 10:20 PM
To: AAA Put this in the To box



  Paul
  Tel me how the driver shaft is attached to the sun gear on
  Tracy is pressure fit ,welded or others??
  i still waiting the shipment of gears

  Jean Prudhomme

  Pressure fit and then two welded in 1/4 or 5/16 pins welded
  in 90 degrees apart. He used to use one and Dave Leonard
  broke it with his turbo.

  Paul Lamar



  Do you think Paul
  Dave took some photos of broken sun gear shaft and do you have more
 clearly
  photos showing the shaft attached to the gear


  Jean Prudhomme

  Here is what I have Jean.

  Paul Lamar


 --
 Paul I receive all the gears components but i guess i do have the wrong sun
 gear for this application it fit on the planet but if i look yous is all the
 same outside diameter and i guess it,s a weak point at the big groove
 I do have the Slauson catalogue, could tell me which part number it can be

 Jean Prudhomme

 I don't have the catalog here. I'll be home in a couple
 of days. That looks like the right part. If it does not fit
 You may have the wrong planet carrier.

 Grind or cut off the teeth on the end you don't use.
 The weak point is not the groove. It is always the root
 of the tooth.

 Paul Lamar

There used to be no pin at all, just rosette welds.  That is what I
broke(not the shaft, and not a pin).  It was not the turbo that did it, but
a backfire due to a bum chip in the computer.  There is a picture on my
website under 'trials and tribulations'.

-- 
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net


Jean, here is all I have on the sun gear.. Use the large part
and the front planet carrier.

There a third in the A4OD. It is the overdrive planet
carrier. That is not the one to use.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.