Subject: Renesis Coils stand alone rotary ignition.
From: Rotary Engine
Date: 10/10/2010, 10:30 PM
To: AAA Put this in the To box



   What do you think of this product, and price.
Also, there are a lot of different individual spark plug coils on Ebay.

http://blackhaloracing.com/products-page/engine/ignition/bhr-ignition-system19/

Hurant Karibian

It is over priced.
The late GM coils are fine but make sure you put a blast tube on them.
1997 to 2005 GM Corvette coils are $30 each on Ebay.
Ignition Coil 97 05 Chevrolet Corvette C1144 Uf192 $29.95 new.


I have had no problems with my 2004 RX8 coils and I run the engine
to 8500 RPM every now and then.

Any old inductive coil will work with this system including the stock
2nd  gen RX7 Mazda coils. Use the dual output coil on
the leading (lower) plugs only.

--------------------------------------------------------

BTW I think the FET is built in to the RX8 and GM Corvette coils so
there is one less part to buy.

I have some Corvette coils so I'll check it out tomorrow.-

--------------------------------------------------
Correction on the number of slots in the trigger
wheel. You only need one slot. Not two.

Make the trigger wheel out of fiberglass so it does
not conduct heat from the end of the e-shaft.


Paul Lamar



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.