Subject: Renesis Coils stand alone rotary ignition.
From: Rotary Engine
Date: 10/10/2010, 7:29 PM
To: AAA Put this in the To box




Does anybody know how the wiring goes for the four individual coils on
the
Renesis engine. It is one of the test engines bought up by that
Australian a
couple of years ago.
There are three wires (black, black with white stripe and the third wire
is
a different color for each coil). The coils black wires are all wired
together with a 0.47uf capacitor attached at the splice, and  the
black/white wires are also wired together but the wire coming out was
cut
off at the splice. -- Karibian

Black with white stripe is 12 volt power
The third wires are triggers from the computer
as follows.

G is green front rotor leading (lower) plug.
W is white front rotor trailing (top) plug.
Y/G yellow / green is back rotor leading plug.
B/O blue /orange is back rotor trailing plug.


Black is ground.

Paul Lamar


 Keep the cap on the ground wires, too.

 Kenny


 These are inductive coils and they normally require a computer.
 Inductive coils are turned on for a period of time and then
 they fire when the current is suddenly turned off. This off time
 is called dwell. If the dwell is too long the coils over heat.
 If too short you don't get full spark energy.

 The breakthrough on how to make this stand alone and work without
 a computer just occurred to me. The trick is to slot the trigger
 wheel and use a  IR photo transistor, an IR emitter LED and FET switch
 instead of a magnetic pickup or Hall Effect sensor. These devices
 put out a single narrow pulse. Not what we need.

 When the IR photo transistor sees the infra red emissions from the
 IR LED it turns the coil current on using an high voltage FET solid state
 switch. I used something like this for years on my computerized
 road test equipment and it is very reliable and durable.

 It will work with just about any stock inductive plug on coil system
 including the Corvette GM coils. The length of the slot controls the
 dwell time. The end of the slot controls when the coil fires.

 I have been thinking about this problem ever since the stand alone
 coil on plug systems first appeared. How do we get rid of
 the computer?

 If you want to fire the leading and trailing plugs at different
 times you can use four slots with four photo TX's and four
 LED's other wise each photo TX fires both leading and trailing
 plug coils at the same time.

 Now some of you electronic types might say "why not just
 use a 555 one shot with a fixed pulse width to turn on
 the current in the coil for a fixed period of time triggered
 by a magnetic sensor or Hall Effect "?

 The problem with that is the spark timing will vary with RPM.
 You want the plugs to fire at 22 degrees TDC over a wide range of
 RPM's so that approach will not work.

 Basically this thing works like distributer points.

 Paul Lamar



Paul,

Will this also work on a 2nd gen?

Any plans to make trigger wheels?

Can the trigger work with an EFI also?

Joe Berki
Limo EZ

It will work on any rotary engine. 2 rotor or 3 rotor.
(3 slots)

Here is a 50 cent improvement. A CMOS 4050 all six gates connected
in parallel drives the FET very reliably.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.