Hello Paul,

Do the parts in the attached photo appear to be part of the
motor mount?  I can't match them to a Zenith part (at least
not yet).  Each is 6 inches long.  The center section is solid
bar stock with bolt holes through the (tube) weldment at the
top and at the bottom of the bar.

Thanks,

William

I have no idea. They do not look like part of the motor
mount. Any Zenith builders out there recognize these?

These are the motor mount pictures Jerry sent.


Paul Lamar



Thanks once again.  Your drawings have already solved the
biggest part of my mystery.  I was able to find the back
bracket strut components and viola' it now makes sense.
The photos and drawings were very helpful!

William


You may have to do a bit of trimming here and there to make those
lower back brackets fit.

We have a newer and better design that you might consider.

Here are some dwgs on that.

The Zenith 801 and the BearHawk have a center upper hard point
on the firewall in common. This design takes advantage of that
hard point.

Paul Lamar