Paul
I did cut down on weight for my housing to adapt to a transmission
bell housing ,i include some notes for the bearings i am projecting to use,
I finished with ALIBRE now i will switch to Rhino and i will have to
learn it but lot of command seems to be similar as ALIBRE
I bought the program as student at $49.00 and registered as member of
EAA and they shipped it without any questions.
I made a hand modification suggestion to fit with Jeff's plate, it
can attached to the same place as the Speed eng housing but i dont
know if it,s enought space to the flywheel.
This is what i came up with the Jeff,s back plate my bearing housing
extend at 1.530" or 39 mm, what is the dimension between his plate
and the front of spline coupling he use on flywheel?
Jean Prudhomme
That is a good question. I don't have the answer as all of that
stuff is up at the hangar. This is as close as I can come.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.