Subject: GEAR BOX WITH LIGHTSPEED ENG HOUSING
From: Rotary Engine
Date: 10/20/2010, 6:18 PM
To: AAA Put this in the To box


Paul
This is my latest design for use the jeff,s plate or transmission housing
Your comments

Jean Prudhomme


I would use a larger diameter hollow shaft with needle bearings.
Saves a lot of weight. Those big old ball bearings are heavy.

Paul Lamar

--

Jean,

Is a press fit collar enough to handle thrust loads of the prop shaft ( not
very high in your pusher design, but...)? How about a threaded
collar and locking ring? How large diameter axle blank does Strange
Engineering have available? They can gun drill internally to lighten the
shaft. Paul had mentioned thin bearings (Kaydon?) that could reduce weight
and take up thrust load.

Dan F

A press fit collar is what Tracy uses.

Paul Lamar

       
LARGER DIAMETER SHAFT IS 45MM
YES I AM WORKING A DESIGN WITH LARGER DIAMETER SHAFT AND USING
NEEDLE BEARING AS PER PAUL SUGGESTED


Jean Prudhomme
              

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.