Paul,
I have made some very nice leading edge wing skins using an
adaptation of Alex Strojnik's method from his Laminar Aircraft
Technologies. I used a wood and plaster male buck of the
leading edge airfoil section. The glass layup was done on a
large smooth flat sheet with a wide layer of thin mylar followed
by a 45 degree fiber glass/epoxy layer covered by a layer of
polyester cloth and then a thin plastic sheet. I rolled the
excess epoxy out of this sandwich lengthwise and sideways with a
length of galvanized pipe filled with concrete for weight. This
rolling minimized any glass cloth distortion that might be
caused by a squeegee.
After the sandwich was partially cured it was draped over the
male buck and weights attached to the hanging mylar and
polyester ends to pull it tight on the buck. When fully cured
the mylar, polyester cloth and plastic sheet were stripped off
leaving a fully filled, bubble free, thin, absolutely smooth and
accurate leading edge skin which can be trimmed and epoxied to
leading edge ribs on a spar to make an very easily finished
leading edge D section.
Obviously, the same process can be used to make large flat
sections for the trailing wing surfaces.
Fred O.
Sounds great. Pictures Fred.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.