Subject: cheap and quick to build composite airplanes Part 3
From: Rotary Engine
Date: 11/4/2010, 7:21 AM
To: AAA Put this in the To box




  Matt-

  I have never built a Rutan type composite airplane but
  I wonder why one cannot sand the foam before applying the
  wet layup to insure an accurate surface.?

  Paul Lamar


One can absolutely sand the core before applying the wet layup.
I understand that  Berkuts were built starting with cores that
were hot wired oversize and which were then sanded to precise
dimensions.


Matt-

Well then what about bonding on pre curred skins with
a finished smooth surface? The spar handles all the bending
loads.

One advantage of the sandwich skin idea above compared to a solid
foam core  is you get more internal volume in the wing for fuel,
control linkages and perhaps landing gear.

No need to make separate hollow strakes.

Paul Lamar


--Another way to build quicker - and still cheap - is to avoid the need of curved surfaces :)

http://www.facetmobile.com/


       Philippe Dejean

Barney Wainfan is relatively local and I have been over
to his hangar and seen the airplane.  An interesting experiment
but not too practical for long distance travel.

My interest in aviation is low cost high speed cross country travel rather than buzzing around the airport low and slow. Here in the western states, cites and other places of interest are far apart, so it takes a lot of time getting anywhere. The same goes for Australia, South America, Africa, China  and Russia only double as four lane high speed roads are rare if not non existent.

The governments in those countries should promote general
aviation and build small airports because it is good for the economy and removes some of the need to build expensive super highways with precious tax money. Perhaps this is giving governments more intelligence and fore site than is warranted ;)

In the eastern part of this country and in Europe one can drive from one place of interest to another in a relative short time
period as the roads are good. Recreational aviation is king. I notice this when I travel to Aero in Friedrichshaven every year.

Lots of light sport size airplanes, motor gliders and very few serious and fast cross country airplanes like the Lancair ES or RV10. I guess it could be related to government restrictions and to disposal income. Low individual taxes. One can see this by looking at Goggle maps of airports around the world. Where I live there are at least four general aviation airports within 40 miles. Santa Paula, Camarillo, Oxnard and Santa Barbara. There are probably 50 within 200 miles of here.

Paul Lamar



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.