Subject: cheap and quick to build composite airplanes Part 3
From: Rotary Engine
Date: 11/4/2010, 11:35 AM
To: AAA Put this in the To box


 Matt-

 I have never built a Rutan type composite airplane but
 I wonder why one cannot sand the foam before applying the
 wet layup to insure an accurate surface.?

 Paul Lamar


One can absolutely sand the core before applying the wet layup.
I understand that  Berkuts were built starting with cores that
were hot wired oversize and which were then sanded to precise
dimensions.


Matt-

Well then what about bonding on pre curred skins with
a finished smooth surface? The spar handles all the bending
loads.

One advantage of the sandwich skin idea above compared to a solid
foam core  is you get more internal volume in the wing for fuel,
control linkages and perhaps landing gear.

No need to make separate hollow strakes.

Paul Lamar



The hollow strakes are to allow the fuel to be carried over the
CG on a twin lifting surface aircraft.  This way, the CG doesn't
change as fuel is burned.

Your method sounds very similar to how the strake tanks were
built on the LongEZ.  Precured skin bonded to prebuilt ribs.

Task Research built strake skins and ribs for the LongEZ.  The
bottom skin was bonded to the center section spar, the fuselage
and an end rib.  Baffles were added, and then the top skins were
bonded in place.
IIRC.

The prefab strakes are more time consuming to build than the
solid core wings, even if you excluded the fuel-specific portion
of their construction.

A lot of starry-eyed, Star Wars wannabes jumped into building
Variezes, LongEZ's, and Cozys.  Way more than jumped into build
Van's RVs before the RVs became prepunched kits.  Many of those
people didn't have any business jumping into the construction of
a flying machine.  Because of this, much ado has been made of
the finishing process of the foam and plastic birds.  My
experience with the stuff is that if you have the right
materials, and the right sand paper, it's really pretty quick
and easy to come up with an acceptable result.  Trying to
cheap-out will cause the result to suck, which is dumb because
the right materials aren't that expensive.

Matt-

I plan on some strength test with the nylon dry wall anchors
screwed into blue foam ribs. It may be possible to
program a NC lathe and spit out thousands at low cost optimized
for attaching skin to foam ribs like nailing plywood
to 2 by 4 studs. I think they can be just pushed into
the foam. A large diameter will increase the shear
strength of the joint. It will take a little experimentation
to find the right diameter.

I checked with my expert consultant on composite construction namely Alex Kozloff who has taught me all I know about everything :) He has just finished building and flying a Pulsar with pre curred foam sandwich wing skins made in a female mold.
No attempt was made to compartmentalize the foam so it is
just foam up to the top skin.

He says to cover the top of the ribs with fiberglass
tape. Don't worry about the joint between the top
of the rib and the glass side of the rib as that will be taken
car of the adhesive that bonds the skin to the rib.

He also loaned me an excellent  book called "Composite
Basics" by Andrew C. Marshall 1985 written from an engineering
point of view.


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.