Subject: Brian Trubee Latest tunning results
From: Rotary Engine
Date: 11/7/2010, 10:54 PM
To: AAA Put this in the To box



I'm in the midst of tuning my engine. I was getting the bogging and then surging right at the point that the secondaries were turning on, and I also seemed to get good results by richening it up for the first 3 bins where the secondaries are cutting in. This is on the ground, of course. I think that I will see some need for tuning in the high RPM/ low MP mapping table when I am in the air  descending. Or maybe not, as I recall the airplane was making a siren song to me that it was running smoothly as I was descending to land, calling for me to go around because it was now smoothing out.

My spark timing is right on the money.

Also, my primaries are 28 lb, and the secondaries are 40 lb injectors, so my staging point is at map station 89~90 right now. I think that might be a little high.

Here's another unrelated  issue- I have an RV-4, with the fuel being taken out of and returned only to the right tank. I have an AN-6 line feeding a facet pump located just aft of the batteries, and it transfers fuel to my right hand tank when I want to transfer the fuel. Both tanks are vented separately. Here's the problem: I started out with 12.5 gallons in the right tank, and 6.5 in the left. After running the engine on the ground for 1 hour, I ended up with 12.7 gallons in the right and 1.7 in the left, without ever having run the transfer pump. The only thing I can think of having happened is that the plane was parked slightly- 1 degree or so-right wing down. The facet pump I believe has a one way valve which would allow fuel to flow  downhill to the right tank. That's my theory, can anyone else offer a theory as to why the fuel is self transferring?

Brian Trubee
RV-4


Your prop turns clockwise tending to lower the left wing
deflecting the landing gear so that is not it. Unless of
course you pull the power quickly and get some spring back
from the landing gear. Then the fuel could slosh into the
right wing through the one way valve in the transfer pump.

Double check the plumbing :)

Where are the fuel tank vents?

BTW sitting in the car the engine from the drivers
point of view the engine rotates counter clockwise.
Therefor when turned around in the tractor airplane
the engine rotates clockwise. Left wing down right
wing up.

The same as your prop so you must be running a 2.85:1 gear
box. Is that correct?

Paul Lamar


Yup, 2.85/1 so I'm turning clockwise from where I sit in the cockpit. The plane was sitting on a slight, very slight grade to the right, so that might have something to do with it. Both tank vents are located next to each other near where the right gear leg exits the fuselage. I ran it for an hour or so, but didn't see any evidence that fuel leaked out anywhere. There was some engine surging,  so I guess the longitudinal rocking could have caused some fuel to slosh to the right, but the left tank was near full, and the engine takes and returns fuel to that tank.
I'm going to hold off on the taps for now, I think I might have the engine running smoothly.

Puzzling.


Brian Trubee

I'll bet the tank vent is facing forward correct?

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.