Subject: EBay pair of huge pport housings
From: Rotary Engine
Date: 11/9/2010, 12:40 PM
To: AAA Put this in the To box


 Depending on the reserve, these could be a good deal for someone:


 http://tiny.cc/wnxdd

 Todd

Hi Paul,   The ports look HUGE!! How do the apex seals manage to slide
over those without breaking? I cannot find any description anywhere of
the alloy side/ end housings, I wanted to get a idea of the cost of
them, one site mentioned that they were "expensive", what isn't?
                 I was interested to see how the inlet ports wers
welded into the housings, which you had put up on one of your posts,
what is the advantage of the ports like that? Why have Mazda not done it
like that?

     John B

They probably do for awhile. There is no pressure difference
across the apex seal in that area so there is little to no
friction between the sides of the apex seal slots and the
apex seals them selves that would prevent them from moving
in and out slightly and rapidly.

Those ports are over kill IMHO and not needed for an aircraft engine.

Paul Lamar

Hi Paul,
                Do you know who makes the alloy side/end pieces for
the 13b motors? I do not seem to be able to find them. I have included a
link to a company in the US developing rotary engines.
              John B.
                             http://www.freedom-motors.com/
That company is vapor ware.

Racing Beat makes the aluminum side housings.
http://www.racingbeat.com/

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.