Subject: The company that makes engine tube mounts from a solidworks file?
From: Rotary Engine
Date: 11/9/2010, 5:40 AM
To: AAA Put this in the To box

I was told that there is a Canadian company that will cut and profile
pipe
to your solidworks file so when you receive the pipe, it goes together
quite
nicely.
If anyone knows of the company, I would love to have the contact
information, thanks!
Bill Holland


I don't know about a Canadian company but there is one here
in California. It is called Industrial Metal Supply
in San Fernando. They have an automated machine that does it.
I am sure there are now a lot of those machines around.

http://www.industrialmetalsupply.com/Services/Laser-Metal-Cutting

Paul Lamar


THANKS
CHRIS

Someone correct me if I'm mistaken, but don't these guys charge an arm and a leg
for this service?
I think the cutting fee for a typical mount was in the thousand dollar range.
C. Smith


Yes they probably do but a lot of it is set up and programming time
I suspect. That is probably why one would need to order ten MM sets
at a time. A small entrepreneur bets the  entire biz every time he
comes out with a new product. One would have to be nuts to make that bet
now.

It might be still cheaper to do it by hand. I have another supplier
now that can do that. Builds a lot of race car roll cages.

BTW I had a similar discussion with the guy in charge at Industrial
Metals. People I have been doing biz with for over 40 years. I expressed
doubt the machine would pay off for them as the cost was enormous.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.