I was told that there is a Canadian company that will cut and profile
pipe
to your solidworks file so when you receive the pipe, it goes together
quite
nicely.
If anyone knows of the company, I would love to have the contact
information, thanks!
Bill Holland
I don't know about a Canadian company but there is one here
in California. It is called Industrial Metal Supply
in San Fernando. They have an automated machine that does it.
I am sure there are now a lot of those machines around.
http://www.industrialmetalsupply.com/Services/Laser-Metal-Cutting
Paul Lamar
THANKS
CHRIS
Someone correct me if I'm mistaken, but don't these guys charge an arm and a leg
for this service?
I think the cutting fee for a typical mount was in the thousand dollar range.
C. Smith
Yes they probably do but a lot of it is set up and programming time
I suspect. That is probably why one would need to order ten MM sets
at a time. A small entrepreneur bets the entire biz every time he
comes out with a new product. One would have to be nuts to make that bet
now.
It might be still cheaper to do it by hand. I have another supplier
now that can do that. Builds a lot of race car roll cages.
BTW I had a similar discussion with the guy in charge at Industrial
Metals. People I have been doing biz with for over 40 years. I expressed
doubt the machine would pay off for them as the cost was enormous.
Paul Lamar
I thought so. If one were building a tube steel airframe, with many pieces, or a
production run of tens or more of a single mount perhaps it might be cost
effective as a time saver. I suspect that even with a multiple run on a single
mount design, their charges will still be pretty steep, as the laser guys expect
to pay off their machines in 12 months, not over 5 years. Not much in the way of
competition, and a specialty niche market. A band saw and a die grinder with a
good assortment of cutters and stones will make short work of the 7-12 pieces
needed for a motor mount. ;-)
C. Smith
There is another way and preferred by my builder and that is
a mill in a vise holding the end of the tube. Harbor freight
has a device that works in a mill or drill press that uses
small hole saws. I have one of those. Works fairly well.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.