Subject: The company that makes engine tube mounts from a solidworks file?
From: Rotary Engine
Date: 11/9/2010, 8:31 PM
To: AAA Put this in the To box


I was told that there is a Canadian company that will cut and profile
pipe to your solidworks file so when you receive the pipe, it goes together
quite nicely.
If anyone knows of the company, I would love to have the contact
information, thanks!
Bill Holland


I don't know about a Canadian company but there is one here
in California. It is called Industrial Metal Supply
in San Fernando. They have an automated machine that does it.
I am sure there are now a lot of those machines around.

http://www.industrialmetalsupply.com/Services/Laser-Metal-Cutting

Paul Lamar


THANKS
CHRIS

Someone correct me if I'm mistaken, but don't these guys charge an arm and a
leg
for this service?
I think the cutting fee for a typical mount was in the thousand dollar
range.
C. Smith


Yes they probably do but a lot of it is set up and programming time
I suspect. That is probably why one would need to order ten MM sets
at a time. A small entrepreneur bets the  entire biz every time he
comes out with a new product. One would have to be nuts to make that bet
now.

It might be still cheaper to do it by hand. I have another supplier
now that can do that. Builds a lot of race car roll cages.

BTW I had a similar discussion with the guy in charge at Industrial
Metals. People I have been doing biz with for over 40 years. I expressed
doubt the machine would pay off for them as the cost was enormous.

Paul Lamar

I thought so. If one were building a tube steel airframe, with many pieces,
or a
production run of tens or more of a single mount perhaps it might be cost
effective as a time saver. I suspect that even with a multiple run on a
single
mount design, their charges will still be pretty steep, as the laser guys
expect
to pay off their machines in 12 months, not over 5 years. Not much in the
way of
competition, and a specialty niche market. A band saw and a die grinder with
a
good assortment of cutters and stones will make short work of the 7-12
pieces
needed for a motor mount. ;-)
C. Smith

There is another way and preferred by my builder and that is
a mill in a vise holding the end of the tube. Harbor freight
has a device that works in a mill or drill press that uses
small hole saws. I have one of those. Works fairly well.

Paul Lamar



A  less costly CNC method is Plasma. There are some low cost plasma
tube cutters. I've even seen them on ebay. Not as slick as laser but
can give nice accurate cuts at low cost. Tube rotates, plasma cutter
moves along tube. It would be easy to make such a machine. Software
might be a problem. I don't know whether or not the plasma heat will
damage the 4130 or not. Any comment?

John McEverett


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.