HI PAUL
There is there up dated design gearbox for constant speed prop shaft ,
Jean Prudhomme
Jean,
I am curious about where the oil supply for the CS prop is getting into and
out of the PSRU. Is it feed off the engine oil? If so, is the PSRU lubed with
engine oil?
Dale Davies
Yes Paul [Dale?] from the engine oil system true prop governor and return to
engine oil pan,the casting have already a port connection for the return line on
the middle of larger bow part of casting it can be turned a different position
on bottom of side depends on oil retention on gearbox.
The prop governor have to be driven by belt but the spline shaft have to be
lubricated or if already one available for belt driven
Jean Prudhomme
Paul
I have to built passageway to each main shaft bearing and return to the main
housing.
Cutted Half small aluminum tubing heavy gauge will be welded outside of the 4"
dia round part as oil lube feeding and the other as return.
I am not at this stage but i do have an idea.
I am well equipped with 250 amps tig welder
Jean Prudhomme
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.