Subject: single rotor engine for sale
From: Rotary Engine
Date: 11/14/2010, 5:40 PM
To: AAA Put this in the To box



  I am thinking of using a single rotor Eng on my Pazmany PL 4
  are there any plans or instructions available ?
  what kind of hp could I expect
  what might the all up weight be.  I need to think about a psrus unit

Ozzie

The Mazda one rotor weight would be around 200 pounds with the cast iron end
housings and the PSRU less the cooling system.
The firewall forward package with cooling system might add another 75
pounds. HP would be about 120 HP with a p-port.

You can save close to 50 pounds by using Racing Beat aluminum end housings.

Paul Lamar

I have a fresh Daryl Drummond built P-port one rotor 13B that would be
perfect for the application.  It has ceramic seals, cast end housings,
alternator, starter, and automatic flywheel, five dyno runs and one hour of
loaded break in time.  It is carbed and has a distributor and I do have the
ECU components for EFI and ignition.

http://www.mikuni.com/fs-carburetor.html

If interested I want to sell the engine because I am changing projects.
I do not have a PSRU but I have seen
several different designs for the 13B Mazda

Bud
karwest@comcast.net


Do you know if Daryl machined the special one rotor e-shaft?
The distributer can be replaced by a CAS to lower the over all height of the
engine.

Paul Lamar


The eshaft is a hardened 300M piece made by a rotary shop in Florida.  Daryl
verified the rotor specs before it was installed
budcoinc

Can you get the name of the shop in Florida.
Other people on here are very interested.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.