Subject: futher noodling of the EFI fuel system
From: Rotary Engine
Date: 11/22/2010, 7:02 PM
To: AAA Put this in the To box


Hello Paul,

OK, so I have a high wing configuration plane with two tanks
in each wing.  Each is plumbed independently.
If I set up two on/off valves, one for outboard (both tanks)
and one for inboard (both tanks)and have the valves drop the
still gravity fed fuel into a header tank (which would of
necessity "vent" back to the two selected tanks); if I then
have the header tank feed the high pressure fuel pump and
have the return (still under pressure from the pump) line
feed trough a check valve back into the header tank, fuel
would return to whichever set of tanks was selected,
wouldn't it?  I guess that assumes that the pressure from
the pump would exceed the gravitational pressure and be
able to put fuel into the header.  Is that doable?

It looks like the simplest fuel management I can do if I
cannot return fuel directly to the tank from which it is
derived.  I'm not sure I have space for four fuel lines
per side going up the cabin side channel, nor are the wings
plumbed for return lines, at present.  Even if I did, I'd
have to have four valves instead of two.  Thoughts?

Thanks,

William Hagood


I would have to do a 3D on this so I can picture the complete system.
It is hard to picture this in my mind. Hang on and  I'll do a 3D shortly.

BTW you can link together 2 much cheaper tank selector valves
so they both move at the same time.


Paul Lamar

William

My SeaWind also has four tanks,two per wing but it is a mid wing.  The design calls for  a solenoid valve to let the outer tanks gravity drain down to the inner ones.  The wing has a camber of course. Work experience with these valves has taught me they are susceptible to clogging as the actual port is only a 3mm dia hole in a dog leg course.  Also depending on an electro-mechanical device has a number of failure situations.  I personally hate tracing wiring faults that have vibrated loose or internally cracked somewhere.

I am considering using an AN-8 size  straight flapper type check valve between the tanks to simplify the system.  The flap valve won't seal 100% when the flight is uncoordinated, say in a slip, but the valve will seal well enough prevent fuel from rushing into the outer tank.  It will   only will seep a small amount in the outer direction, say less than a cup over a ten minute period.

So now the plane in effect  has two large interconnected tanks, each with its manually operated  cut-off valve, and gasolator sump,  located in  the wing roots.


Doug in Japan.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.