Subject: Single Rotor E-shaft details
From: Rotary Engine
Date: 11/23/2010, 6:49 AM
To: AAA Put this in the To box





  Paul
  Thank you for the photos of the single rotor e-shaft. Are there any
  dimensioned sketches available? I want to make a drawing for my
  machinist. I can back most of the details out of the twin e-shaft if I
  knew the width of the single eccentric.

  I found an interesting cooling detail using a expansion chamber for
  the coolant overflow.  Is this more complicated than it needs to be?
  Th elowest portion of the page below.

  http://www.canardaviation.com/cozy/chap23i.htm

  Matt Naiva

  Here is an Autocad dwg from George Grimes I think.
  What drawing program are you using?

  Paul Lamar

 Paul
 Thank you! I will likely use Pro-E although the machinist would likely
 prefer a dxf file. I was reviewing the exploded drawings on the
 following link. There appears to be some sort of a counter weight on
 the flywheel end. Are there any special balancing requirements for the
 single rotor?

 http://www.rotorparts.co.za/Info.html

 Matt Naiva


 It is kind of tricky to design counter weights for a one rotor.
 I think Pro -E will give you the centroid of a solid which
 might help.

 Here are the mathematical formulas for balancing.

 Paul Lamar

The formulas above work pretty well. I used those for calculating the
correction on the front counter weight, and designing the fly wheel There
was very little correction to be made on the dynamic balancer. I did that on
two sets with the same results.

Richard Sohn
N2071U



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.