Subject: Single Rotor E-shaft details
From: Rotary Engine
Date: 11/24/2010, 8:43 AM
To: AAA Put this in the To box

  It is kind of tricky to design counter weights for a one
  rotor.
  I think Pro -E will give you the centroid of a solid
  which
  might help.

  Here are the mathematical formulas for balancing.

  Paul Lamar

  The formulas above work pretty well. I used those for
  calculating the
  correction on the front counter weight, and designing the
  fly wheel There
  was very little correction to be made on the dynamic
  balancer. I did that on
  two sets with the same results.

  Richard Sohn
  N2071U


  Paul,

 This balance diagram is the uncorrected one with the rear mass mislabeled
on
 the one rotor portion.

 Dan Stanzione

 Here is the corrected version.

 Paul Lamar

This is a great community, transparent sharing of talents and gifts is
refreshing.
Obviously each one of us are the "mechanic in charge"  but it really
helps to have the opportunity to learn from others triumph and
tribulations!  I just checked out a vintage RX-2 rebuild manual from
the library. Very detailed!

Richard
Is there significant weight advantage to starting a single from a 12a vs a
13b?
The E-shaft drawing is for a 12 is the 13 shaft the same?

Regards,

Matt Naiva

 Matt, a single rotor 13B, every thing else the same, would have a better
power/weight ratio than a 12A. Overall weight would certainly be higher.
The e-shaft would obviously longer. Also, power take off would have to be
different. I have not done any detailed work on it at this time.

Richard Sohn
N2071U

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.