Subject: further noodling of the EFI fuel system]
From: Rotary Engine
Date: 11/25/2010, 12:52 AM
To: AAA Put this in the To box


Paul / William,
I used the Zenith-supplied rubber fuel lines for everything, including the EFI
return. Heintz anticipated the EFI line, as the aft-edge door frame trim piece
has room for two lines side by side. On the left door (one line), I ran my fuel
line and wing wiring harness up the trim. On the right side, I ran the fuel and
EFI lines under the trim, and the wiring harness behind the post. Not enough
room for all three under the trim.

Attached is a photo of the left side, aft edge, with me holding the fuel line
and harness in position to check fit. I've wrapped the harness in a nylon
sheath, then wrapped that with permacell 'tape' (very slick stuff) to prevent
chaffing between the two.

Second photo is the right side trim piece (painted green) installed. The fuel
lines are under the 'cap' that forms the backing for the door when closed.

Also, Tracy used to sell a 60 psi Bosch fuel pump with metric / an adapter
fittings; that's what I have.

--Kenny A.


-- 
Kenneth,

Very helpful!  Thank you, and happy Thanksgiving to all.

William Hagood


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.