Subject: Low cost off the shelf parts for the Ellison
From: Rotary Engine
Date: 12/9/2010, 3:48 PM
To: AAA Put this in the To box


http://tinyurl.com/28gc2bo
http://www.tillotson.ie/

This is going to save a pile of money
making a dual Ellison for our P-ports.

Some of the Ellison parts are bought
from Tillotson. Brilliant idea on the
part of Ellison. Cuts his cost enormously.
Rotec is probabbly doing the same thing.

I was going to use Holley parts but
this is 1000% better.

Paul Lamar


Paul,  I remember the tillotson carburetor as used on late 1960's Harley
Davidson. I used two front cylinder heads and two  tillitson
carburetors on 1200cc big twin engines. They were trouble free and
started well with a kick starter. There is a small vent hole in the
center of the diaphragm cover on the bottom of the carburetor. We used
to make a "tickler" out of a paperclip to lift the diagfram on cold
winter days to get fuel before cranking the engine. I never had to take
one apart for cleaning or repair. The only problem was that I used an
optional high speed adjustment screw with a handwheel about the size of
a quarter. My customers just couldn't leave it alone.I did a lot of high
gear maximum speed adjusting on route 7 resetting them.

I needed the
handwheel for initial set up because trying to keep a screw driver in a
screw head at 125 MPH was just plain ugly. I remember buying carburetors
and parts from an address in tillotsonville Ohio and thought that was
where they were manufactured. I bought over the phone and mailed a check
without ever making the 70 mile trip over there. Options were the
Linkert, ball and ball, SU (from a Jaguar) amal gran prix seies(remote
float bowl), mikuni, webber, and  the lake injector. All the options
were harder to tune requiring jet or metering rod changes and only the
mikuni made better power. Getting a good idle and full load settings on
the options always seemed mutually exclusive.

 Forty years ago a new tillotson was$39 from the factory about
twice that from Herley Davidson and the webber was $270. At those prices
three tillotsons on a side port RX8 would be attractive. Put a control
lever on the mixture handwheel with a cable control.

george grimes

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.