Subject: Low cost off the shelf parts for the Ellison
From: Rotary Engine
Date: 12/11/2010, 7:57 AM
To: AAA Put this in the To box



  http://tinyurl.com/28gc2bo
 http://www.tillotson.ie/
  This is going to save a pile of money
 making a dual Ellison for our P-ports.
  Some of the Ellison parts are bought
 from Tillotson. Brilliant idea on the
 part of Ellison. Cuts his cost enormously.
 Rotec is probabbly doing the same thing.
  I was going to use Holley parts but
 this is 1000% better.
  Paul Lamar

  -----------------------------------------------------

  Here is the latest 3D's.

  The stock ACRE slide throttle parts are used.
  The slide itself is modified for the brass tube
  with all tiny holes in it.

  The pressure regulator is a copy of the Ellison which
  uses stock Tillotson pressure regulator parts. Same
  as Ellison did.

  The pressure regulator is designed to bolt to the
  stock slide housing using the existing bolt holes.

  The fuel is fed into the center of the brass tube
  and then out to each runner.

  Craig, did you get a quote on the laser holes?

  Paul Lamar



Very cool Paul.  I don't have anything else to contribute but I think
you guys are really on to something with this.

Everett


I figured out a way to get the regulator back into the center
of the slide throttle. It involves milling a slot in the outer cover.

Another anticipated problem is drilling a real long straight hole
in the slide. Usually that is done with a special (expensive) device called
a gun drill.  That can be solved by making the slide in two
pieces and linking them together when assembled. Each piece has
the tube hole drilled separately.

I also think I can get some more weight out of the regulator
block. It will have to be completely redrawn but I will wait
for  that until I get a set of Tillotson parts.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2010 All world wide rights reserved.